Denso
Overview
Section titled “Overview”Couples Denso RC8/RC9 controllers and the WinCaps virtual controller (b-CAP). Platform: Windows only.
Set up and parameters
Section titled “Set up and parameters”| Parameter | Example |
|---|---|
| Host | 127.0.0.1 |
| Controller type | RC8 or RC9 |
| WinCaps project | C:\Projects\Cell1\Cell1.WPJ |
Addresses are VRC variable symbols: IO<n> for a Boolean, I<n> integer, F<n> float, S<n> string. Joint positions are published as <interface>.axis1 … axisN; an address axis<n> binds a joint under a signal name of your own instead. A virtual controller connection needs the WinCaps project file on the gateway PC.
A position variable P<n> becomes six signals <name>.x, .y, .z (mm) and .rx, .ry, .rz (degrees) plus <name> holding the robot figure, where <name> is the signal’s name. As a PLCOutput it is read; as a PLCInput it is written as one position with the figure the controller reported — and, like every write, only with write access.
Create or import signals
Section titled “Create or import signals”- Manually. Enter the VRC variable symbol:
IO<n>(Boolean),I<n>(integer),F<n>(float),S<n>(string),P<n>(position).axis<n>binds a joint under a name of your own. - Browse. No browse: enter addresses by hand.
- File import. No file import. A virtual controller connection needs the WinCaps project file on the gateway PC, but it is not a signal source.
- From the model. Use Addresses → Import address table… in the signal-mapping section of the CONNECT panel: a CSV or TSV with
name;address[;dataType[;topic]]rows, where the name is the model’s signal name. New signals take direction and type from the same-named model signal; signals that already exist keep their configured type. Fill from controller… has nothing to match, because this protocol cannot be browsed. See Configuring interfaces.
How direction, data types and write access are decided is explained in Common concepts and Configuring interfaces.
See also
Section titled “See also”- Common concepts — text signals, direction, write access, tracking signals
- Configuring interfaces — adding signals, direction and write access
- All supported interfaces
- Troubleshooting — connection and signal problems